Commit Graph

7 Commits (c9e838b6560fb7981062fef2762762e9cf4e748f)

Author SHA1 Message Date
Anton Blanchard 21f482f967 Reformat testbenches
Signed-off-by: Anton Blanchard <anton@linux.ibm.com>
4 years ago
Anton Blanchard ab86b58d95 Exit cleanly from testbench on success
Signed-off-by: Anton Blanchard <anton@linux.ibm.com>
5 years ago
Paul Mackerras 8160f4f821 Add framework for implementing an MMU
This adds a new module to implement an MMU.  At the moment it doesn't
do very much.  Tlbie instructions now get sent by loadstore1 to mmu,
which sends them to dcache, rather than loadstore1 sending them
directly to dcache.  TLB misses from dcache now get sent by loadstore1
to mmu, which currently just returns an error.  Loadstore1 then
generates a DSI in response to the error return from mmu.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>
5 years ago
Paul Mackerras 750b3a8e28 dcache: Implement data TLB
This adds a TLB to dcache, providing the ability to translate
addresses for loads and stores.  No protection mechanism has been
implemented yet.  The MSR_DR bit controls whether addresses are
translated through the TLB.

The TLB is a fixed-pagesize, set-associative cache.  Currently
the page size is 4kB and the TLB is 2-way set associative with 64
entries per set.

This implements the tlbie instruction.  RB bits 10 and 11 control
whether the whole TLB is invalidated (if either bit is 1) or just
a single entry corresponding to the effective page number in bits
12-63 of RB.

As an extension until we get a hardware page table walk, a tlbie
instruction with RB bits 9-11 set to 001 will load an entry into
the TLB.  The TLB entry value is in RS in the format of a radix PTE.

Currently there is no proper handling of TLB misses.  The load or
store will not be performed but no interrupt is generated.

In order to make timing at 100MHz on the Arty A7-100, we compare
the real address from each way of the TLB with the tag from each way
of the cache in parallel (requiring # TLB ways * # cache ways
comparators).  Then the result is selected based on which way hit in
the TLB.  That avoids a timing path going through the TLB EA
comparators, the multiplexer that selects the RA, and the cache tag
comparators.

The hack where addresses of the form 0xc------- are marked as
cache-inhibited is kept for now but restricted to real-mode accesses.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>
5 years ago
Paul Mackerras b349cc891a loadstore1: Move logic from dcache to loadstore1
So that the dcache could in future be used by an MMU, this moves
logic to do with data formatting, rA updates for update-form
instructions, and handling of unaligned loads and stores out of
dcache and into loadstore1.  For now, dcache connects only to
loadstore1, and loadstore1 now has the connection to writeback.

Dcache generates a stall signal to loadstore1 which indicates that
the request presented in the current cycle was not accepted and
should be presented again.  However, loadstore1 doesn't currently
use it because we know that we can never hit the circumstances
where it might be set.

For unaligned transfers, loadstore1 generates two requests to
dcache back-to-back, and then waits to see two acks back from
dcache (cycles where d_in.valid is true).

Loadstore1 now has a FSM for tracking how many acks we are
expecting from dcache and for doing the rA update cycles when
necessary.  Handling for reservations and conditional stores is
still in dcache.

Loadstore1 now generates its own stall signal back to decode2,
so we no longer need the logic in execute1 that generated the stall
for the first two cycles.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>
5 years ago
Benjamin Herrenschmidt 8e0389b973 ram: Rework main RAM interface
This replaces the simple_ram_behavioural and mw_soc_memory modules
with a common wishbone_bram_wrapper.vhdl that interfaces the
pipelined WB with a lower-level RAM module, along with an FPGA
and a sim variants of the latter.

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
5 years ago
Benjamin Herrenschmidt cb4451498f dcache: Add testbench
A very simple one for now...

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
5 years ago