dcache: Update TLB PLRU one cycle later

This puts the inputs to the TLB PLRU through a register stage, so
the TLB PLRU update is done in the cycle after the TLB tag
matching rather than the same cycle.  This improves timing.
The PLRU output is only used when writing the TLB in response to
a tlbwe request from the MMU, and that doesn't happen within one
cycle of a virtual-mode load or store, so the fact that the
tlb victim way information is delayed by one cycle doesn't
create any problems.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>

dcache.vhdl

@@ -249,6 +249,11 @@ architecture rtl of dcache is
         hit_index        : index_t;
         cache_hit        : std_ulogic;
 
+        -- TLB hit state
+        tlb_hit          : std_ulogic;
+        tlb_hit_way      : tlb_way_t;
+        tlb_hit_index    : tlb_index_t;
+
 	-- 2-stage data buffer for data forwarded from writes to reads
 	forward_data1    : std_ulogic_vector(63 downto 0);
 	forward_data2    : std_ulogic_vector(63 downto 0);
@@ -567,15 +572,15 @@ begin
 		    lru => tlb_plru_out
 		    );
 
-	    process(tlb_req_index, tlb_hit, tlb_hit_way, tlb_plru_out)
+	    process(all)
 	    begin
 		-- PLRU interface
-		if tlb_hit = '1' and tlb_req_index = i then
+		if r1.tlb_hit_index = i then
-		    tlb_plru_acc_en <= '1';
+		    tlb_plru_acc_en <= r1.tlb_hit;
 		else
 		    tlb_plru_acc_en <= '0';
 		end if;
-		tlb_plru_acc <= std_ulogic_vector(to_unsigned(tlb_hit_way, TLB_WAY_BITS));
+		tlb_plru_acc <= std_ulogic_vector(to_unsigned(r1.tlb_hit_way, TLB_WAY_BITS));
 		tlb_plru_victim(i) <= tlb_plru_out;
 	    end process;
 	end generate;
@@ -1146,6 +1151,11 @@ begin
                 r1.stcx_fail <= '0';
             end if;
 
+            -- Record TLB hit information for updating TLB PLRU
+            r1.tlb_hit <= tlb_hit;
+            r1.tlb_hit_way <= tlb_hit_way;
+            r1.tlb_hit_index <= tlb_req_index;
+
             -- complete tlbies and TLB loads in the third cycle
             r1.tlbie_done <= r0_valid and (r0.tlbie or r0.tlbld);
 	end if;