Recent litedram gets stuck at memtest unless block_until_ready=False.
(discussion in https://github.com/enjoy-digital/litedram/pull/292)
This change regenerates with latest litedram and litex
62abf9c ("litedram_gen: Add block_until_ready port parameter to control blocking behaviour.")
add2746a ("tools/litex_cli: Rename wb to bus.")
Signed-off-by: Matt Johnston <matt@codeconstruct.com.au>
Note: There are a few patches to upstream to fix an upstream breakage
of litedram standalone generator, and fix some issues with liteeth
in the way it's used on Wukong. All these have pending pull requests.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
This makes the 64-bit wishbone buses have the address expressed in
units of doublewords (64 bits), and similarly for the 32-bit buses the
address is in units of words (32 bits). This is to comply with the
wishbone spec. Previously the addresses on the wishbone buses were in
units of bytes regardless of the bus data width, which is not correct
and caused problems with interfacing with externally-generated logic.
Signed-off-by: Paul Mackerras <paulus@ozlabs.org>
This is a NiteFury based PCIe M2 form-factor board originally
used for mining. It contains a speed grade 2 Artix 7 200T,
1GB of DDR3 and 32MB of flash.
The serial port is routed to pin 2 (RX) and 3 (TX) of the P2
connector (pin 1 is GND).
Note: Only 16MB of flash is currently usable until code is added
to configure the flash controller to use 4-bytes address commands
on that part.
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Matt Johnston
Paul Mackerras